EPAX Replacement LCD screens and Mono screens (Official EPAX Replacement part) X1 X10 E6 E10 X1N X1K

EPAX Replacement LCD screens and Mono screens (Official EPAX Replacement part)

The screen is a special SHARP screen for the EPAX X1 and X1-N 3D printer ONLY. Using this screen with any other similar LCD printers is not supported.

Since day one, all our 5.5 LCD screens have both SX04(internal default) and SX03 interfaces. The SX04 to SX03 converter is covered/hidden by black tape. To use the screen on EPAX X1-N printers, you will need to carefully remove the black tape on screen's cable to expose SX04 interface.

The screen has tempered glass installed on top. So even if you spill resin or have a small resin leak, you can gently remove the resin without damaging the screen. Do not leak resin under the screen through edges. It is strongly recommended that you cover the edges with our pre-cut screen tape or with 0.1mm thick kapton tape, if needed.

Monochrome LCD screens last much longer than color screens (with proper use your screen should last several thousand hours). This screen has tempered glass installed on top. So even if you spill resin on top of it you can gently shovel it off without damaging the screen.

#3DPrinting #3DPrint #ResinPrinter #EPAX #Resin #SLA #DLP #LCD #LCDReplacement #X1 #LCDscreen #E6 #E10 #Monoscreen #MonoLCDReplacement