EPAX Gray Water Washable Resin - General Purpose 3D Printing Resin for mSLA 405nm 3D Printer

EPAX Water Washable Resin

❗❗ 500g manufacturing date: November 2020

✨Water-soluble and can be cleaned up using room temperature tap water instead of isopropyl alcohol. It is low-odor in addition to avoiding the odor associated with IPA used in the clean-up of standard resins.

Oily looking right after printed but it is actually good looking after cured and dried. It is also less easily get moisture impact. It is compatible with most LCD printers that use 405nm wavelength UV light.

❗❗ NOTE: the water used in post-processing and clean-up must be exposed to UV light before disposal and should not be poured directly down any drain.

✔️ Shake well before use
✔️Wear a gloves and mask for safety
✔️ Store at 15-35 ℃ in a cool, dry place. Keep away from direct sunlight to avoid unwanted curing
✔️ Seal well after use to avoid contamination

👍 Compatible with Anycubic, Creality, Elegoo, Phrozen, Peopoly and other resin printer brands
Also including Creality LD002H, EPAX, and Peopoly mSLA printers

⚠️ Precautions:
This product should not be ingested. Keep away from children. Do not put in your eyes. In case of accidental contact, flush with running water as soon as possible for at least 15 minutes. If skin is irritated, consult a doctor immediately. Always use gloves when handling uncured resin

Also available:
- Anycubic General Resin
- Anycubic Eco Resin
- Monocure Flex 100
- Monocure TUFF
- EPAX Hard for large format printers
- EPAX Hard and Tough ABS like
- EPAX Dental
- EPAX Jewelry Castable
- EPAX Water Washable

#3DPrinting #3DPrint #3DPrinter #Resin #EPAX #Anycubic #PhotosensitiveResin #Photon #SLA #DLP #3dresin #elegoo #mars #creality #photopolymer